<< Prev        Next >>

ID : 5887

Overview

Mounting an optional parallel I/O board on the RC8 robot controller Safety I/O less specification and connecting the I/O conversion box allows the signals fed to the "INPUT connector (CN8)", "OUTPUT connector (CN10)" and "I/O POWER connector (CN7)" on the RC5 controller to be used as-is. This function is available in Ver.1.8.6 or higher.

For the Pin Assignment on Connectors when the I/O conversion box is connected, refer to the "RC5 CONTROLLER INTERFACE MANUAL".

  • The power supply setting (internal or external) and transistor type (NPN or PNP) need to be the same in between the Mini I/O and Parallel I/O.
  • I/O conversion box is not applicable to robot controllers other than RC8 robot controller Safety I/O less specification.
    For example, I/O conversion box is not applicable to RC8 robot controller standard specification, RC8A robot controller safety I/O less specification, and other robot controllers.

ID : 5887

<< Prev        Next >>