<< Prev        Next >>

ID : 3421

Packed Items

Items Contained in the Robot Jacket Set

The robot jacket set for food processing contains the items shown in the table below.

Robot Jacket

Part name Part image
  • Robot jacket: 1

  • Jacket tightening band: 4

    • For tightening near the robot base (60 cm): 2

    • For adjusting the looseness of the arm (90 cm): 1

    • For tightening at the jacket bottom (146 cm): 1

    * Only the jacket can be ordered when it is needed to be solely replaced.

Accessories

Part name Part image
  • Robot jacket mounting flange-A: 1
  • Mounting bolt: 4
    • Bolt size: M5x30 (stainless steel bolt)
  • Dowel pin: 1
  • End-effector installing O-ring: 1
  • Robot jacket mounting flange-B: 1
  • Mounting bolt: 4

    • Bolt size: M5x40 (iron bolt)

  • Dowel pin: 1
Robot jacket tightening hose clamp: 1
  • 6th-axis cross roller protective cover: 1
  • Mounting screw: 1 set (4 screws)

    • Cross screw size: M3x10
  • End-effector signal and pipe connector protective cover: 1
  • Mounting bolt: 2

    • Bolt size: M3x8 (silver)
  • End-effector signal line and air pipe guide: 1 set (left and right)
  • Mounting cross screw: 4

    • Cross screw size: M3x16

Options

The quantities of the following items are specified by the customer.

Part name Part image
  • Cable ground, seal plug, thin head screw plug

    • Select from the five cable grounds and seal plugs according to the wiring/piping type used for the end-effector and installation method.

    * The following optional items are required:

    • Cable ground 1 (wire diameter: Φ5 to 8 mm)
    • Cable ground 2 (wire diameter: Φ3 to 5 mm)
    • Cable ground 1 seal plug
    • Cable ground 2 seal plug
    • Thin head screw plug
  • Washing protective cover
  • Protective cover fixing bolt
  • Seal washer

ID : 3421

<< Prev        Next >>