Making the Defined Interference Check Areas Active or Inactive

The number of interference check areas that can be defined by the area function is 32 and they are defined by AREA0 to AREA31.
Out of those defined areas, areas to be actually used may be selected according to the procedure given below.
Only the necessary areas should be made active.
The options of surveillance cycles are 2ms,4ms,8ms,16ms,32ms.
For the operating procedures, refer to "How to Display and Set Areas" of Smart TP Operation Guide.

Number of the enable area

As a default, there is no restriction of the number of the active area according to the surveillance cycle.

If you want to limit the number of the active area, set the parameter [36: Area check mode] to [0: Divide] in the [VRC setting] window.

For the operating procedures, refer to "VRC Setting" of Smart TP Operation Guide.

If the area check mode is set to "Divide", the number of the active area differs depending on the surveillance cycle as shown below. If the specified area exceeds the available range, an error [0x832012FAL：Enable area count is upper limit] will appear.