ID : 5545

DeviceNet Connector

The pin assignment of DeviceNet connector is shown below.

When the controller power (including the network power) is ON, do not disconnect/connect the communication connector or touch its pins. Doing so will result in a failure.

It is recommended that either of the following crimp terminals be used for the communications cable.

No.	Crimp terminal	Tools required	Note
(1)	AI series (Phoenix Contact)	ZA3 (Phoenix Contact)
(2)	TC series (Nichifu) For thin cables: TC 0.3-9.5 For thick cables: TC 2-11 (for power supply) TC 1.25-11 (for communication)	NH-69

No.

Crimp terminal

Tools required

Note

(1)

AI series (Phoenix Contact)

ZA3 (Phoenix Contact)

(2)

TC series (Nichifu)

For thin cables: TC 0.3-9.5

For thick cables: TC 2-11 (for power supply)

TC 1.25-11 (for communication)

NH-69

ID : 5545

<< Prev Next >>