<< Prev        Next >>

ID : 5629

Changing the L Axis Mechanical End

Restriction of Motion of L Axis

The motion of the L axis can be restricted using optional mechanical stoppers. The mechanical stoppers consist of two stopper blocks and four stopper bolts.

Change the mechanical stopper installation positions to set a motion range.

Installation of Mechanical Stoppers

The figure below shows the reference positions for stopper blocks and stopper bolts.

1

Loosen the four stopper bolts M12×50 mm and remove the two stopper blocks.

2

Move the stopper blocks by 195 mm.

3

Install the stopper block with stopper bolts. Tightening torque: 42.2N・m±20%

This is the end of the mechanical stopper installation.

ID : 5629

<< Prev        Next >>