I/O Setting

This section describes how to set the I/O port number that is connected to the sensor detecting workpiece, and the edge type.

Setting Procedure

1 Displaying the Number Selection Window

Press [I/O Number].

I/O setting window is displayed.

2 Setting Number

Enter the I/O number to use, then press [OK].

Available I/O numbers are listed below.

User input	No.8 to 15
Hand input	No.48 to 55

3 Setting the Edge Type

Choose desired [Edge type] then press [Next].
Edge type is selected.

For details about each edge type, see the table below.

Rising edge	To detect a workpiece at the rising edge
Falling edge	To detect a workpiece at the falling edge
Rising and Falling	To detect a workpiece at the rising edge and falling edge

This continues to "Hardware Connection Confirmation".