Ethernet (Configuring WINCAPSIII)

Configure the PC in WINCAPSIII so that WINCAPSIII can communicate with the robot controller via Ethernet.

1

Choose Project | Properties to display the Property window and then choose the Communications setting tab.

The interface can be also specified with the WINCAPSIII Project wizard. Even after the wizard is finished, the interface can be changed with the procedure given below.

2

Make sure that Ethernet is selected and enter the IP address of the robot controller.

3

If needed, specify the timeout period and the number of retries and then press OK.

Under normal condition, these values may stay at default.

The communications setting for the PC has been completed.