<< Prev        Next >>

ID : 5887

Overview

Connecting the I/O conversion box to some models of RC8 series robot controllers with the optional parallel I/O board mounted on them allows the signals fed to the "INPUT connector (CN8)", "OUTPUT connector (CN10)", and "I/O POWER connector (CN7)" on the RC5 controller to be used as is. This function is available in Ver.1.8.6 or higher.

The box is applicable to the following robot controllers.

  • Safety I/O–less RC8
  • Safety I/O–less RC8A with the engine board type-E

For the Pin Assignment on Connectors when the I/O conversion box is connected, refer to the "RC5 CONTROLLER INTERFACE MANUAL".

  • The power supply setting (internal or external) and transistor type (NPN or PNP) need to be the same in between the Mini I/O and Parallel I/O.
  • The I/O conversion box cannot be used for Safety I/O–less RC8A if its engine board type is “N” or “7”.

    You can check engine board type on the name plate attached to the controller.
    For more information about controller type, refer to here.

ID : 5887

<< Prev        Next >>