ID : 9450

SysLog.Trace.Start

Function

To start trace log recording.

Syntax

SysLog.Trace.Start

Description

Executing this command will specify the start timing of the log data that you can obtain.
The range of log data you can obtian is specified by the combination of this command and STOPLOG command (SysLog.Trace.Stop), or by the combination of this command and the parameter that specifies the logging-end timing.
If CLEARLOG command (SysLog.Trace.Clear) has not been executed, the program automatically executes CLEARLOG process and then starts obtaining the log data.

For details, refer to "Recording by Program Commands" in the "Logging" Basic of Robot Motion Creation.

Attention

See "Displaying the Trace Log" in "Smart TP Operation Guide" for about how to check the trace log with a Smart TP.
See Acquisition of Log Data in "WINCAPSIII GUIDE" for about how to export controller's log data to WINCAPSIII.
See "Displaying and Reading Project List" in "Smart TP Operation Guide" for about how to export controller's log data to a USB.

Example

Sub Main 
	SysLog.Trace.Clear
	SysLog.Trace.Start
	
	TakeArm
	Motor On
	ExtSpeed 50
	Speed 100
	
	Move P, P1
	Move P, P2
	Move P, P3
	
	SysLog.Trace.Stop 
End Sub