<< Prev        Next >>

ID : 2935

Installing the Flange Kit (Option)

The flange kit consists of a flange, fixing bolt (M5x16), and setscrew (M4x6). Install the flange to the T-axis shaft according to the procedure below.

  1. Wipe off oil from the circumference of the T-axis shaft which the flange should be fitted on.
  2. Loosen the setscrew of the flange so that the flange can be fitted on the T axis.
  3. Push the flange until it comes into contact with nut end "A", and then rotate the flange so that the setscrew becomes aligned with the flat section of the T-axis shaft.
  4. Gradually tighten the setscrew until it comes into contact with the flat section of the T-axis shaft and the flange can be rotated without looseness. Then torque the setscrew to 1.6±0.3 Nm.
  5. Tighten the fixing bolt (M5x16) to 8.8±0.9 Nm for securing the flange.

Installing the Flange Kit

 

ID : 2935

<< Prev        Next >>