HOME
ID : 2648
Connecting Male and Female Connectors
1
Check the position of a depression and a protrusion of connectors.
2
Couple the protrusion and depression, and then push the male connector into the end of the female connector (until three threads remains visible).
Do not turn the connector before the male connector completely reaches to the end of the female connector. Doing so will damage the connector.
If the male connector is installed in the female connector properly, you will feel a slight clicking sensation when you turn the connector.
3
Turn the male connector (a connector on the cable side) to the clockwise for 180 degrees (1/2 rotation) to complete. About two threads remains visible though, it is normal condition.
Do not tighten them with a plier or a long nose plier. Doing so, strong force may apply to the screw part, this may degrade the waterproof performance and damage to the terminal. Tightening process must be done by hands or a wrench (torque wrench).
ID : 2648