HOME
ID : 888
Mounting the CALSET Jig
To CALSET the 6th axis, you need to align the 5th axis with its CALSET position.
1
Fit a stopper pin in the CALSET jig.
2
Release the brake of the 6th axis.
3
Install the CALSET jig on the flange of the 6th axis as shown in the figure below and the figure on the next page.
The CALSET position of the 6th axis refers to the point where the stopper pin (shown below) comes into contact with bolt (A) when the flange of the 6th axis is turned.
Mounting a CALSET Jig [VM-6083/VM-60B1]
ID : 888