HOME
ID : 1478
Project Property Setting
To use a CC-Link remote device board as an I/O expansion board, you need to register the following information from WINCAPSIII.
From the [Project] menu, point to [Property] to open the Property window, and then click .[I/O] tab. For details, refer to "Configuring a Project".
Assign
Device
| Setting value | |
|---|---|
| Device | "CC-Link RD" or "[Parallel] + [CC-Link RD]" |
Mode
"Standard" indicates the Standard mode, and "Compatible" indicates the RC3 Compatible mode. For details about allocation modes, refer to “Functions in Individual Allocation Modes ”.
| Setting value | |
|---|---|
| Mode | "Standard"or "Compatible" |
Options MiniIO
Power source
If the total maximum capacity of Mini I/O, Hand I/O and Parallel I/O is 1.3 A or lower, the internal power source is available.
| Setting value | Defalt setting | |
|---|---|---|
| Power source | "External" or "Internal" | External |
Options CC-Link
Only "Occupied stations" and "Extended cyclic setting (for Ver.2.00)" can change the number of User I/O.
Set desired I/O numbers with referring to "I/O Allocation".
Version
| Setting value | Defalt setting | |
|---|---|---|
| Version | "1.1" or "2.0" | 1.1 |
Station number
| Setting range | Defalt setting | |
|---|---|---|
| Station number | 1～63 | 1 |
Occupied stations
| Setting range | Defalt setting | |
|---|---|---|
| Occupied stations | 2～4 | 4 |
Extention Cycles
Extension Cycle setting is available from Version 2.00 or later. You do not need to set this if your CC-link version is 1.1.
| Setting range | Defalt setting | |
|---|---|---|
Extention Cycles |
"1", "2", "4" or "8" | 1 |
Baud Rate
| Setting value | Defalt setting | |
|---|---|---|
| Baud Rate | "156K", "625K", "2.5M", "5M" or "10M" | 10M |
ID : 1478
- Related Information
- I/O Allocation