Replacement of Cableveyor

This page contains a description of replacing a cableveyor when it is broken or worn out.

Split and reconnect a cableveyor where replacement is needed according to the procedure shown below.

Splitting of Cableveyor

1

Open the two arms at the splitting position.

Insert a flat-blade screwdriver into a gap between the arm edge and the link at the opening-closing side, turn the screwdriver to the right and left to open the two arms.

2

Insert a flat-blade screwdriver into a gap between links as shown in the figure below, pull the screwdriver toward yourself, and remove the pin from the hole.

3

Using the other pin as a pivot, bend the cableveyor into a dogleg shape to split it.

Reconnection of Cableveyor

1

Replace the worn link with a spare part. Align the split cableveyors with the arms open at the reconnecting position.

2

With the links overlapped, insert a pin into a hole on one side.

3

Insert another pin into a hole on the other side.

4

Either press the arm edge by hand or hit it with a plastic hammer until an audible click is heard.

This is the end of cableveyor replacement.