ID : 2870

Selecting the Conveyors and Devices

Choose a conveyor number and type of device to be configured.

Selection Procedure

1 Displaying the Tracking Setting Window

Choose [F10 Tracking] from the top window.

To use [F10 Tracking], the license of the circular tracking is required.

"Tracking" window is displayed.

To set the conveyor or to edit the items of the [F12 Detail], the log-in level needs to be the Maintainer or the higher.

2 Displaying the Conveyor Setting Window

Press [Settings].

Before pressing [Setting], set the "Enabled" on the left side of [Setting] to OFF state. You cannot press [Setting] when the "Enabled" is set to ON state.
Setting the conveyor to OFF state after executing one of the following commands, the value set by each command is written into the parameter.
TrackStartArea, TrackOffsetMargin, TrackTargetOffset, TrackMinimumIntervalLength

3 Setting the Conveyor

Choose [Circular] and press [Next].
Turntable is selected.

4 Setting the Device

Choose [Sensor] and press [Next].
[Sensor] is selected.
Once pressing [Stop] - [OK], the calibration is canceled, and then the "Tracking" window is displayed.

This continues to "Setting of the Encoder Joint Number".

ID : 2870

<< Prev Next >>