Installing the Flange Kit (Option)

The flange kit consists of a flange, fixing bolt (M6x16), and setscrew (M5x8). Install the flange to the T-axis shaft according to the procedure below.

1. Wipe off oil from the circumference of the T-axis shaft which the flange should be fitted on.
2. Loosen the set screw of the flange so that the flange can be fitted on the T axis.
3. Push the flange until it comes into contact with nut end "A," and then rotate the flange so that the set screw becomes aligned with the flat section of the T-axis shaft.
4. Gradually tighten the set screw until it comes into contact with the flat section of the T-axis shaft and the flange can be rotated without looseness. Then torque the set screw to 3.6±0.6 Nm.
5. Tighten the set screw 2 just the same way as the set screw 1. (You can tighten the set screw 1 and 2 in any order.)
6. Tighten the fixing bolt (M6x16) to 14.7±2.94 Nm for securing the flange.

Installing the Flange Kit