HOME
ID : 5364
Programming
This chapter describes sample programs of the conveyor tracking.
- When you perform the teaching with 4-Axis robots, set the 4-th axis around 0 degrees.
- For the Control set of motion optimization (SpeedMode), select "0: None" or "1: PTP".
- Conveyor-related commands cannot be executed in the teach check mode. If you execute these commands in the teach check mode, an error "82201808 Change to automatic mode to execute the command" will be issued.
- For two or more robots, each slave obtains the workpiece data by using the same process as the master.
- When executing tracking more than twice to the same work, that work could be registered doubly due to the problem of calibration precision. Each conveyor needs to be calibrated respectively.
Position Where the Return Values of Each Command Indicate
Related Terms
TrackCurPos, TrackInRange, TrackOffsetMargin, TrackStandByPos, TrackTargetPos
ID : 5364
- Related Information
- Programming Examples of the Sensor Tracking
- Programming Examples of the Vision Tracking
- Deleting Tracking Buffer Data
- Equipment Protection by Area Function
- Free Curve Interpolation of Tracking
- Target Position Adjustment and Relative Motion of Conveyor Tracking
- Time Left to Downstream Limit
- Programs for Extended-joint Tracking
- Programming for the Dual Arm Control Function-Used Operation
- Target Position Check of Robot Task Motion