ID : 7374

MC_SetArea

To activate detection in a designated detection area.

Graphic expression	AOI category
	Non motion

Input and Output Variable

Variable name	Data type	Valid range	Conditions for Input and Output
AxesGroup	eRC_AxesGroup		-
AxesGroup	Robot group Specify a robot variable (structured type data : eRC_AxesGroup) of user-defined type.

Input Variable

Variable name	Data type	Valid range
Execute	Boolean	TRUE : Start FALSE : -
Execute	Execution start When the variable is changed from FALSE to TRUE, this AOI is executed.
AreaNo	Integer	0 to 31
AreaNo	Area number Specify an area number.

Output Variable

Variable name	Data type / Description
Done	Boolean
Done	Execution completion confirmation TRUE : This AOI execution is completed. FALSE : This AOI execution is not completed.
Busy	Boolean
Busy	Processing status of this AOI TRUE : Being executed. FALSE : Not being executed.
Error	Boolean
Error	Error presence TRUE: This AOI ended abnormally. FALSE : This AOI ended successfully.
ErrorID	Integer
ErrorID	Error location 2800 : The error occurred in the PLC program. 2801 : The error occurred in the robot controller.
ErrorIDEx	DInt
ErrorIDEx	Error Code This is a number to identify the error description. For details, refer to "Error code list".

Function Description

Attention

If you the change work coordinates during area interference (area check) function enabled state, depending on the system, it will take up to 10ms before the new work coordinate is reflected into the interference check area judgment.
To use the new work coordinate for the area interference check without fail, before you change the work coordinate, set the robot so that the area interference does not occur (such as stop the robot motion), wait until the new work coordinate is applied to the system, and restart the robot.

ID : 7374

<< Prev Next >>