Single-Cycle Check

Press [Display] at the bottom of [Program list] window to check program contents during single-cycle check.

Operation procedures

1

Set operating mode switch to [TEACHCHECK].

Teach check icon will be displayed on the leftmost of the status bar.

2

Press [F1 Program].

The following [Program list] window will be displayed.

3

Select the program to check by using cursor key or jog dial, or by directly touching the screen.

The selected program will be highlighted.

4

Press [OK] while pressing the deadman switch on teach pendant to turn on the motor.
The [MOTOR] lamp turns on.

Motor cannot be turned on when the deadman switch is not pressed.
Release the deadman switch to turn off motor.

5

Set external speed, acceleration, and deceleration of robot by using [SPEED] button of teach pendant or by directly touching speed bar on the screen.

6

Press [F4 CycleStart] on the program list screen in STEP 3.
The following system message will be displayed.

7

Press [OK] while pressing the deadman switch. Keep pressing both deadman switch and [OK] until the execution of program is completed.
Robot stops immediately if either of them is released before completing the execution.